Unilock Fence Installation Nationwide

Unilock Fence Installation: The Pomona Owner’s Guide

Unilock fence installation in Pomona typically runs $3,500-$9,000 for a complete vinyl or aluminum system, depending on linear footage, terrain, and whether we’re anchoring into decomposed granite or standard soil. Most Pomona homeowners who call us notice the problem after a wind event - a section leaning at the Fairplex corridor, pickets pulling free near Ganesha Park, or posts that have shifted in the clay-heavy soil after the first winter rains. We stock Unilock-compatible posts, rails, and bracket hardware for same-day stabilization, and we carry the full line for replacement when the original system has reached its limit.

Call (626) 606-1081

Which Unilock Models This Applies To

Unilock’s fence line breaks into two families: the U-Grip vinyl systems (white, tan, and clay colors, with 5-inch square posts and 2-inch top rails) and the Alumilock aluminum series (1.5-inch pickets with concealed fastener rails). The U-Grip 400 and 600 series share post dimensions but use different bracket spacing - 48 inches on-center versus 72 inches - and mixing them will leave your rails unsupported at mid-span. Alumilock posts come in 2.5-inch and 3-inch square extrusions; the 3-inch carries the commercial wind-load rating you’ll want if you’re backing onto the 71 freeway corridor or any Pomona property with open exposure.

To identify your system, check the post cap for a molded “U-L” or “AL” stamp, or measure the wall thickness of a cut rail sample - U-Grip residential runs 0.055 inch, commercial 0.090 inch. We source OEM Unilock components through their Ontario distribution center, though for discontinued color matches we often fabricate from quality aftermarket stock that meets the same ASTM F964 vinyl spec or AAMA 2604 aluminum coating standard. The aftermarket route saves roughly 15-20% on material when the color match is close enough, and we document the spec sheet in your file so there’s no mystery about what went in.

Signs Your Unilock Fence Installation Is Failing

• Posts leaning or rotating at grade. In Pomona’s expansive clay soils, the concrete footing heaves with moisture cycles and the post base loses plumb. The bracket may look intact, but the post is levering against a void that grows with each wet season.
• Rails pulling out of post pockets. U-Grip’s snap-lock rail design depends on a clean, square insertion; UV fatigue or impact damage warps the rail end, and the locking tab no longer engages. You’ll hear it rattle before you see the gap.
• Picket spacing widening at mid-span. The bottom rail has sagged, either from thermal creep in vinyl or from a missing internal aluminum stiffener in older Alumilock runs. The pickets stay straight; the rail between posts does not.
• Gate dragging or latch misalignment. Hinge posts take the dynamic load every time the gate swings, and in Pomona they settle differentially from the latch post. The gap you notice is rarely the gate; it’s the post pair no longer in the same plane.
• Surface cracking or chalking on vinyl, or white corrosion bloom on aluminum. After eight to twelve years of inland-empire UV and occasional Santa Ana wind abrasion, the capstock degrades. Alumilock’s powder coat can fail at fastener points where galvanic reaction starts; we catch this early on inspection.

Before

After

Replacement Cost & What’s Included

For a typical Pomona residential lot, complete Unilock fence installation runs $3,500-$9,000 installed. The low end covers 80-100 linear feet of U-Grip vinyl in flat terrain with direct soil burial; the high end reflects Alumilock aluminum on sloped grade with core-drilled concrete footings, decorative post caps, and a walk gate with self-closing hardware.

What drives the spread: soil condition (decomposed granite versus expansive clay), access for our auger truck, and whether we’re matching a partial replacement to faded existing material. Under Clause 1 of The Haven Standard, you get the full written price before we start - every post counted, every footing spec’d, no “we’ll see once we’re in” language. The 365-Day Done Right Promise covers workmanship; manufacturer defects run through Unilock’s own limited lifetime residential warranty, which we register for you at completion.

DIY or Call Us?

There’s a short list of checks a Pomona homeowner can safely make: confirm the post is loose by rocking it at grade, verify the rail hasn’t simply popped out of its pocket (a firm push sometimes reseats U-Grip), and clear soil away from the concrete footing to see if it’s cracked or tilted. What we don’t recommend is digging out and re-pouring a post footing yourself - the concrete mix, embedment depth (30 inches minimum in Pomona’s frost-heave zone, per local amendment), and plumb tolerance of 1/4 inch in 8 feet all matter more than they appear. A post that looks straight at noon leans by 3 p.m. if the footing isn’t square to the string line.

Gate hinge adjustment looks simple but strips quickly if you’re using the wrong driver on a stainless fastener in aluminum. We’ve replaced enough DIY attempts to know where the afternoon goes wrong. Call (626) 606-1081 and we’ll scope it, photograph what we find, and give you the fixed price to make it right - or tell you it’s a ten-minute fix you can handle yourself. Measure twice, then we can talk.

FAQs